Here is a gift I made for my daughter this Christmas that I thought I would share. Constructed of Philippine mahogany with 1/4″ birch-ply backing it’s mahogan-’E’. Based on multiples of 5 1/2″ the boxes will fit in any location on the shelf; 3 across the bottom, stacked several high or one here one there.

The shelf was finished with Sikkens Cetol Log Decor then a low-lustre BL Interior Clear topcoat. The boxes were colored with Master’s Solar-Lux dye then covered with 3 coats of Sikkens Interior Clear.

The lumber was all milled to 5/8″ or less and finished with two coats before assembly with a pin nailer. Because of the ultra-low profile of the 23 gauge brads, I only used glue and many pins for the assembly. I predrilled two holes in the birch ply 16″ o.c. for mounting and wrapped each box separately with another wrapped gift in each one.

I enjoyed the result of the letters I made for pulls. Before setting to the the bandsaw, I decided a hand drawn letter looked much better than a stencil or ruler drawn letter and all three of these came out matching italic capital letters.  After finishing each with a chisel, sharp knife, sand paper and dye they really look sharp!